Starlink V3 and pez dispenser CKAN

Take ur V3 starlinks. Load your magazine, reach orbit, open the payload door, and release a satellite train. Features - Animated dispenser: moving feed carriage, retention clamps, guide rails and visible satellite stack. - Virtual magazine: stored satellites contribute mass and cost without requiring dozens of separate physical parts. - Flexible deployment: release one satellite, a selected quantity, or the whole magazine automatically. - Adjustable settings: payload count, satellite wet mass, release interval and separation speed. - Functional satellites: probe core, relay antenna, batteries, unfolding solar arrays and xenon electric propulsion. - Deployment checks: door interlock, exit-clearance checks and electric-charge requirements. - Mass simulator: an alternative payload for testing. - Includes stock/RSS scale patches, estimated RO settings, full source code and editable model files. Requirements KSP 1.12.5 and ModuleManager for compatibility patches. Install Starship Expansion Project and its dependencies separately for the intended Starship setup. Installation and use Copy GameData/StarshipPEZ into your KSP installation’s GameData folder. In the VAB, attach SPDS PEZ Satellite Dispenser to the Block 3 nosecone’s internal node_pez, with symmetry off. Configure your payload, then deploy in space at 1× time: Open door → Run Setup Check → Check Exit Clearance → Arm → Deploy The nominal load is 30 satellites. Loads up to 60 are available for open-rack testing; enclosed fitting at that capacity is unverified. Development release Version 0.3.6 includes fixes for payload loading, Block 3 door detection and satellite spawn placement. Further testing across flight conditions and mod combinations is ongoing. Satellite dimensions and performance are estimates inspired by Starlink V3.